ok lunch break. tested out mapping a knob on my midi controller(its a custom knob box that uses an arduino leonardo) within vcv using the fundamental midi map module (as shown in manual), mapped to the slider in the bog mix1(with a ref sine tone module running into it)… and then transferred the yml over to the mm via 1st kvm, switched over to the midi controller via 2nd kvm, and it worked just fine on the mm. definitely way easier to map midi knobs via vcv than setting all mappings up on the mm.
and just tried in vcv to map the mm knob A to the mix1 (after i’d already midi mapped my knob to it) and it seemed to just override the midi mapping with the mm knob A one. so there’s that. i think in most cases most people won’t need to have both midi knob and mm knob mapped to the same thing… or if they did they could use the fundamental cv mix module, but of course with that one you can only use a virtual cable from there. hopefully we can see something like stoermelders ‘umap’ functionality in mm at some point (to map the output of any module to any other virt knob, button or slider)
fwiw i am use the latest firmware 1.4.1 mentioned here