I think this is all related to the discussion we had here
(simplified take from that discussion)
patches are loaded into memory, and if you make ANY change (e.g adjust a parameter), it gets marked as ‘changed’ (red dot).
the issue then is… the MM has no idea if its reasonable to ‘bin’ this change even it knew the sd card version was different…
e.g. did you just alter a parameter, or did you make big changes that you want to keep ?
I think the intended behaviour is, it reloads from sdcard IF the loaded patch as not been changed at all (no red dot) , otherwise it does not.
you can then use revert, to force a reload.
one oddity, which I think still exists is… if you load/open from card, (regardless if you unmounted or not) , it will not load if patch is change.
I think this is ‘wrong’, as you are kind of explicitly stating you want the one on the card.
I guess, is a pop up dialog - in the scenarios where its unclear if MM should reload from sdcard or not. this was talked about in above topic.
(e.g. patch changed on card, you ask to reload from card etc)